Quiz Summary

0 of 10 questions completed

Questions:

You have already completed the quiz before. Hence you can not start it again.

Quiz is loading…

You must sign in or sign up to start the quiz.

You must first complete the following:

Results

Quiz complete. Results are being recorded.

Results

0 of 10 questions answered correctly

You have reached 0 of 0 point(s), (0)

Answered
Review

Question 1 of 10

1. Question
A new collar arrives on site. Which of the following should be checked ASAP?
- Pin and Box Connection types
- OD
- All IDs
- Material density
- Connections quality/ conditions
- Shoulder sealing surfaces
- Serial Number
- Length
Question 2 of 10

2. Question
How should the size of Centralizer Fins on tool modules be checked?
- Measure the Fin with a Vernier Caliper and compare against the collar paperwork.
- Perform a physical test fit, installing the Fin in the Collar.
- Check the delivery ticket for the tool module and compare against the collar paperwork.
- Wait until you install the toolstring on the rigfloor. If it fits..it fits!
Question 3 of 10

3. Question
Which of the following are sources of magnetic interference?
- Volcanic activity
- Drillstring components
- Casing
- Nearby wells
- Rubber debris in the circulation system
- Iron rich formations
Question 4 of 10

4. Question
Which of the following are inputs when determining the amount of non-magnetic spacing that is needed.
- Expected run length
- Maximum expected inclination during the run
- Maximum expected azimuth during the run
- Minimum expected inclination during the run
- Maximum angular offset from magnetic north or magnetic south
- Maximum vertical depth (TVD)
Question 5 of 10

5. Question
Which of the following offsets are entered into standard mwd decoder and logging software packages?
- Bit to Directional sensor
- Bit to UBHO downhole shoulder
- Bit to Gamma sensor
- Bit to UBHO bolt holes
- Bit to top of MWD
- Bit to Battery
Question 6 of 10

6. Question
When performing a Field Roll Test using Eclipse Touch software, which of the following variables are included in the test?
- Magnetic Field Strength
- Inclination
- Azimuth
- Gravity Field Strength
- Dip Angle
Question 7 of 10

7. Question
Why is the Toolface Offset procedure completed?
- To physically align the Muleshoe to the Directional Module
- To measure the Motor to Muleshoe angular offset
- To correct for temperature increases when downhole
- To quantify the angular offset between the Lower End Keyway and the Directional Module reference axis
Question 8 of 10

8. Question
Black Diamond Remote Ops pre-run approval of logging corrections, log headers and sensor offsets are required before every gamma run
- TRUE
- FALSE
Question 9 of 10

9. Question
When Warning or Critical shock and/ or vibration levels are seen what is the first step in mitigation that should be performed by the driller?
- Lift off bottom
- Stop rotating
- Increase rotation
- Reduce flowrate by 25%
- Increase Weight on Bit [WOB] by 10%
Question 10 of 10

10. Question
When a failure occurs, why is it critical to reprot the issue on the job MWS Teams channel ASAP?
- As a record of the timing of the issue
- To ensure all Black Daimond parties who may need to support the resolution, or discuss the issue with the customer, are aware of the failure
- To accelerate a tool replacement shipment
- To ensure the customer is aware of the issue

Quiz Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question

9. Question

10. Question